MGB Tops ALMOST Install Themselves!

Although the installation of an MGB top is fairly straight forward (and clearly detailed in a couple of the books we sell), many people prefer to have it done professionally. But what if there is not a good ‘top shop’ near where you live, or if you’d rather not pay to have it done? For just such situations, we are pleased to announce a new line of imported tops which practically install themselves! These tops, especially imported from England, come complete with the header rail already installed. Putting them on your car is a breeze…

In the case of stow-away type tops,simply remove top from sealed plastic bag. Breath in genuine English air or save for later installation in your Dunlops! Install old latches on the header rail with a Phillip’s screwdriver.

Now that the hard part is completed take a break or, if you’re the impatient sort rush ahead and erect top as you normally would. Complete installation including swapping the latches can be completed in about 5 minutes! (Not including beer or coffee break).

All versions of our MGB tops with header rails are supplied with all fasteners, snaps and rear anchor bar fully installed. They also include the seal for the header rail pre-installed and trimmed for a draft free, leak free seal.

Later tops must be screwed to the top frame and incorporate a strip of fabric which should be glued to the rear bow of the top frame. Even these aspects can be completed in another 5-10 minutes with the same Phillips screwdriver and tube of household fabric cement.

These tops are manufactured in England to exact original specifications in all respects. Each and every top is jig fitted over a full scale MGB monocoque by factory trained technicians to insure a perfect fit. Start this season off with a Moss top built to fit right!